Backup

Table of Contents

Select File Catalog to Backup
Add...
Modify...
Advanced...
Select Backup Device
Recording
Recording Complete

This fuction supports backing the recorded data to CD-R/RW, DVD-R/RW, DVD+RW, USB hard disk, USB flash memory, and the data can be selected by date, time and camera.

Select File Catalog to Backup

Select File Catalog to Backup

Figure 2.38. Select File Catalog to Backup


To back up the recorded data on disk, the file catalog to back up have to be added. The files to back up will be added by clicking Add... button by date, time and camera. The information for the added file catalog is shown in order, the total size of all the added files is shown below the check button of the camera. The camera can be selected when an added file is selected, and it can be modified, removed and described with detail information. After finishing adding file catalog, clicking Forward button is needed.

Add...

Add File List Screen 1

Figure 2.39. Add File List Screen 1


Above picture is the first screen of the step to add files to the list to back up. Clicking Add... button is needed to proceed to the next.

Add File List Screen 2

Figure 2.40. Add File List Screen 2


The start date to back up should be selected on calendar. Then, select the start time from timeline and clicking Set... button is needed.

Add File List Screen 3

Figure 2.41. Add File List Screen 3


The end date should be selected in same order of the start date. Even if the order of the start date(From) and the end date(To), file lists will be obtained automatically. Then, the selection of the number of the camera to back up is needed. Clicking OK button is needed to proceed.

Modify...

Modify File List Screen

Figure 2.42. Modify File List Screen


This button modifies the file list which will be back up. Selection target in a similar manner to adding and clicking OK button are needed.

Advanced...

Advanced Information for File List Screen

Figure 2.43. Advanced Information for File List Screen


This button shows detail information of the file list to backup, the paths and the size of the contained file name. The specific file can be removed from the file list by deselecting it. The deselected files are displayed with red striked line and it will not be backed up.

Select Backup Device

Select Backup Device Screen

Figure 2.44. Select Backup Device Screen


The list of available devices for backup is displayed in this area. CD-R/RW, DVD-R/RW, DVD+RW, USB CD-R/RW, USB hard disk, USB flash memory are supported. If the device is not scanned to the system, it will not be appeared in the list. Clicking Forward button is needed after selecting device to back up.

Recording

Backup Progress Screen

Figure 2.45. Backup Progress Screen


After ready for backup, backup will be begun by clicking Recording button. The button will be disabled when the total combined size of the files to back up is exceeded the maximum storage size. To change backup configuration, you can click Cancel button to start configuration again from beginning or Back button to move to the previous page.

[Warning] Warning

If the backup is started once, you must not cancel it before it is finished.

Recording Complete

Recording Complete Screen

Figure 2.46. Recording Complete Screen


To record the same file list again after finishing backup successfully, Recording button should be clicked after moving to the previous page by clicking Back button.