Relay Preference

Table of Contents

Overview
Configure

Overview

You can configure the action properties of relays which are executed from Remocon or Relay Job.

Relay preference

Figure 3.19. Relay preference


Configure

All relays can be configured to have their own action properties basically. If you select Host and Relay in the Condition and change the action properties, it's applied to only selected relay device. However, if you check Use the same setting for all relays button, all relays have the same properties.

Properties which define the way of relay action, consists of following items:

Type

You can select the relay action type from one of the `N/C' or `N/O'. `N/C' is the state change from 0 to 1, and `N/O' is the contrary.

Duration

It adjusts the time during which the relay is activated.

Interval

It adjusts the time during between relay actions in case of 'Counts' property is greater than 1.

Counts

It adjusts the count for the relay action.